PWM’s full range of cold pressure welding machines, including two portable models for bonding trapezoidal profile, were exhibited at wire 2018. Visitors to stand 9B41 were be able to see PWM’s proven cold weld technology in action and try out the machines for themselves.

The air/hydraulic HP100 and HP200 cold welders enable operators to weld non-ferrous material 1.00mm to 6.50mm diameter without effort. Portable and simple to use, these versatile machines will join wire, strip and profile, including trapezoidal profile for manufacturing cable for sub-sea applications. Power consumption is minimal since the machines require only a supply of compressed air and they can be moved easily to the work area, saving effort and reducing downtime.

The P1500, the largest cold welder in PWM’s range, was also on show. Designed for bonding large rod sections up to 25.00mm copper and 30.00mm aluminium, the electro/hydraulic P1500 is quiet and economical to operate. The smaller electro/pneumatic EP500, one of PWM’s best-selling machines, has a capacity of 5.00mm to 12.50mm copper; 5.00mm to 15mm aluminium. Both machines are energy efficient, dependable, clean and user-friendly. Like all PWM machines, no set up time is required and the welds produced are reliable, consistent and stronger than the parent material.

PWM’s best-selling manual M101 machine for wire sizes 1mm to 5mm, the BM10 and BM30 models for wire 0.10mm to 1.80mm and three smaller hand-held cold welders for joining fine wire were also exhibited.

Media contact: Steve Mepsted
+44 (0) 1233 820847
This email address is being protected from spambots. You need JavaScript enabled to view it.